CAUTION / NOTICE / HINT
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
REMOVE FRONT WHEELS
REMOVE NO. 1 ENGINE UNDER COVER
REMOVE REAR ENGINE UNDER COVER LH
REMOVE REAR ENGINE UNDER COVER RH
DRAIN MANUAL TRANSAXLE OIL
for Manual Transaxle: Click hereНажмите здесь
for Multi-Mode Manual Transaxle: Click hereНажмите здесь
REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
SEPARATE FRONT SPEED SENSOR
Click hereНажмите здесь
SEPARATE FRONT FLEXIBLE HOSE
Click hereНажмите здесь
SEPARATE TIE ROD END SUB-ASSEMBLY
Click hereНажмите здесь
SEPARATE FRONT STABILIZER LINK ASSEMBLY
Click hereНажмите здесь
SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Click hereНажмите здесь
SEPARATE FRONT DRIVE SHAFT ASSEMBLY
Click hereНажмите здесь
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH.
Do not damage the transmission case oil seal.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Perform the same procedure as for the LH side.
REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH
Using a screwdriver, remove the front drive shaft hole snap ring.