СИСТЕМА МЕХАНИЧЕСКОЙ ТРАНСМИССИИ "MULTIMODE" Engine does not Start

DESCRIPTION

If any malfunctions are suspected in the transaxle control system after reassembling or repairing transaxle system components, perform troubleshooting in accordance with the following chart.

PROCEDURE

  1. CHECK DTC OUTPUT

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Multi-Mode M/T / Trouble Codes.

      Powertrain > Multi-Mode M/T > Trouble Codes

    5. Read the DTCs using the GTS.

      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B
    B

    GO TO DTC CHART Click hereНажмите здесь

    A

  2. READ VALUE USING GTS (LEARN-CLUTCH STOP POINT)

    1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Learn-Clutch Stop Point.

      Powertrain > Multi-Mode M/T > Data List
      Tester Display
      Learn-Clutch Stop Point

    2. In accordance with the display on the GTS, read the Data List.

      Result
      Result Proceed to
      Executed (Exec) A
      Not executed (Notexec) B
      Failure (Fail) C
    B

    PERFORM INITIALIZATION Click hereНажмите здесь

    C

    CHECK CLUTCH SYSTEM (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here Нажмите здесь

    A

  3. READ VALUE USING GTS (LEARNING-T/M)

    1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Learning-T/M.

      Powertrain > Multi-Mode M/T > Data List
      Tester Display
      Learning-T/M

    2. In accordance with the display on the GTS, read the Data List.

      Result
      Result Proceed to
      Executed (Exec) A
      Not executed (Notexec) B
      Failure (Fail) C
    B

    PERFORM INITIALIZATION Click hereНажмите здесь

    C

    CLEAR LEARNING VALUE AND EXECUTE LEARNING AGAIN (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here Нажмите здесь

    A

  4. READ VALUE USING GTS (GEAR POSITION (CURRENT))

    1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Gear Position (Current).

      Powertrain > Multi-Mode M/T > Data List
      Tester Display
      Gear Position (Current)

    2. Move the shift lever to N (neutral).

    3. In accordance with the display on the GTS, read the Data List.

      Result
      Result Proceed to
      Neutral (N) A
      Other than neutral (N) B
    B

    CHECK TRANSAXLE ASSEMBLY (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here Нажмите здесь

    A

  5. INSPECT NEUTRAL POSITION SWITCH

    1. Inspect the neutral position switch.

      Click hereНажмите здесь

      Result
      Proceed to
      OK
      NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here Нажмите здесь

    NG

    REPLACE NEUTRAL POSITION SWITCH Click hereНажмите здесь