PROCEDURE
PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click here Нажмите здесь
REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
Click here Нажмите здесь
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here Нажмите здесь
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Click here Нажмите здесь
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Click here Нажмите здесь
SEPARATE NO. 1 AIR CLEANER INLET
Remove the bolt and separate the No. 1 air cleaner inlet.
REMOVE ECM
Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 connectors from the ECM.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the 2 bolts, clamp and ECM.
REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket.
REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket.