ДАТЧИК ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ СНЯТИЕ

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here Нажмите здесь

  2. REMOVE FUEL FILTER ASSEMBLY

    Click hereНажмите здесь

  3. DISCONNECT ENGINE WIRE

    1. Disconnect the engine wire from the ECM.

      1. Raise the lever while pushing the lock on the lever, and disconnect the ECM connector.

        A012GEF

      2. Disconnect the 2 engine wire connectors and 2 clamps.

        A012NC2

  4. REMOVE FUEL FILTER SUPPORT

    Click here Нажмите здесь

  5. REMOVE AIR CLEANER BRACKET

    Click here Нажмите здесь

  6. REMOVE SHIFT STROKE SENSOR

    1. Disconnect the wire harness clamp.

      A012KLK

    2. Disconnect the shift stroke sensor connector.

    3. Remove the 2 screws and shift stroke sensor from the shift and select actuator.

      A012FWE

    4. Remove the O-ring from the shift stroke sensor.