ДАТЧИК ХОДА СЦЕПЛЕНИЯ (для EC65A) УСТАНОВКА

PROCEDURE

  1. INSTALL CLUTCH STROKE SENSOR

    1. Apply MP grease to a new O-ring.

      A012MUBC01
      *a Sensor Arm (Clutch Stroke Sensor Side)
      *b Sensor Arm (Clutch Actuator Assembly Side)

    2. Install the new O-ring to the clutch stroke sensor.

    3. Set the clutch stroke sensor so that the clutch stroke sensor side and the clutch actuator assembly side arms are in the positions shown in the illustration.

    4. Turn the clutch stroke sensor clockwise and install it with the 2 screws.

      Момент затяжки
      1.96 N*m  { 20 kgf*cm, 17 in.*lbf }

    5. Connect the connector to the clutch stroke sensor.

  2. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click hereНажмите здесь

  3. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click hereНажмите здесь

  4. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM

    Click hereНажмите здесь

  5. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM

    Click hereНажмите здесь