ГОЛОВКА БЛОКА ЦИЛИНДРОВ РАЗБОРКА

PROCEDURE

  1. REMOVE INTAKE VALVE

    1. Place the cylinder head sub-assembly on a wooden block.

    2. Using SST, compress the inner compression spring and remove the valve spring retainer locks.

      A012JE5N01
      SST
      09202-70020

    3. Remove the valve spring retainer, inner compression spring and intake valve.

      Tip:

      Arrange the removed parts in the correct order.

  2. REMOVE EXHAUST VALVE

    1. Place the cylinder head sub-assembly on a wooden block.

    2. Using SST, compress the inner compression spring and remove the valve spring retainer locks.

      A012IEKN01
      SST
      09202-70020

    3. Remove the valve spring retainer, inner compression spring and exhaust valve.

      Tip:

      Arrange the removed parts in the correct order.

  3. REMOVE VALVE STEM OIL SEAL

    1. Using needle-nose pliers, remove the valve stem oil seal.

      A012H66

  4. REMOVE VALVE SPRING SEAT PLATE WASHER

    1. Using compressed air and a magnet hand, remove the valve spring seat plate washer by blowing air onto it.

      A012GID