PROCEDURE
INSPECT CLUTCH DISC ASSEMBLY
Using a vernier caliper, measure the rivet head depth.
Minimum Rivet Depth |
---|
0.3 mm (0.0118 in.) |
If necessary, replace the clutch disc assembly.
Install the clutch disc assembly to the manual transaxle assembly.
Insert the clutch disc assembly in the correct direction.
Using a dial indicator, measure the clutch disc assembly runout.
Maximum Runout |
---|
0.8 mm (0.0315 in.) |
If necessary, replace the clutch disc assembly.
INSPECT CLUTCH COVER ASSEMBLY
Using a vernier caliper, measure the depth and width of the diaphragm spring wear.
Maximum |
---|
A (Depth): 0.5 mm (0.0197 in.) |
B (Width): 6.0 mm (0.236 in.) |
If necessary, replace the clutch cover assembly.
INSPECT FLYWHEEL SUB-ASSEMBLY
Using a dial indicator, check the flywheel sub-assembly runout.
Maximum Runout |
---|
0.1 mm (0.00394 in.) |
If necessary, replace the flywheel sub-assembly.