PROCEDURE
INSTALL DIESEL THROTTLE BODY ASSEMBLY
Install a new gasket and the diesel throttle body assembly with the 2 nuts and 2 bolts.
Connect the connector to the diesel throttle body assembly.
Connect the No. 6 water by-pass hose to the diesel throttle body assembly, and slide the clip to secure it.
Connect the No. 7 water by-pass hose to the diesel throttle body assembly, and slide the clip to secure it.
INSTALL NO. 3 AIR HOSE
Align the embossed mark of the throttle body with the paint mark of the No. 3 air hose.
*a | Embossed Mark |
*b | Rear |
*c | RH |
*d | Paint Mark |
Align the embossed mark of the No. 2 air tube within the paint mark of the No. 3 air hose.
Tighten the hose clamp of the No. 3 air hose on the diesel throttle body assembly side.
Align the paint mark of the air hose with the protrusion and push in the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
Position the clamp so that distance A is 4 to 9 mm (0.157 to 0.354 in.).
Tighten the hose clamp of the No. 3 air hose on the No. 2 air tube side.
Align the paint mark of the air hose with the protrusion and push in the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
Position the clamp so that distance A is 9 to 15 mm (0.354 to 0.591 in.).
ADD ENGINE COOLANT
Click hereНажмите здесь
INSPECT FOR COOLANT LEAK
Click hereНажмите здесь
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL FRONT LOWER BUMPER ABSORBER
INSTALL NO. 1 ENGINE COVER
Click hereНажмите здесь
PERFORM INITIALIZATION
Click hereНажмите здесь