PROCEDURE
INSTALL SELECT STROKE SENSOR
Apply MP grease to a new O-ring.
Install the O-ring to the select stroke sensor.
Set the select stroke sensor so that the sensor side and actuator side sensor arms are positioned as shown in the illustration.
Turn the select stroke sensor clockwise.
Install the 2 screws.
Connect the select stroke sensor connector.
Connect the 2 wire harness clamps.
INSTALL AIR CLEANER BRACKET
Click here Нажмите здесь
INSTALL FUEL FILTER SUPPORT
Click here Нажмите здесь
CONNECT ENGINE WIRE
Click hereНажмите здесь
INSTALL FUEL FILTER ASSEMBLY
Click hereНажмите здесь
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here Нажмите здесь
PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSAXLE SYSTEM
Click hereНажмите здесь
PERFORM LEARNING OF MULTI-MODE MANUAL TRANSAXLE SYSTEM
Click hereНажмите здесь
PERFORM SYNCHRONIZATION POSITION CALIBRATION
Click hereНажмите здесь