МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В СБОРЕ СНЯТИЕ

CAUTION / NOTICE / HINT

Note:

When the manual transaxle assembly is removed, be sure to use a new clutch release with bearing cylinder assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder assembly to return to its original position. Dust from the moving section may damage the seal of the clutch release with bearing cylinder assembly, possibly causing clutch fluid leaks.

PROCEDURE

  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here Нажмите здесь

  2. REMOVE FRONT ENGINE MOUNTING INSULATOR

    Click here Нажмите здесь

  3. REMOVE REAR ENGINE MOUNTING INSULATOR

    Click here Нажмите здесь

  4. REMOVE NO. 1 AIR TUBE

    1. Disconnect the 2 wire harness clamps from the manual transaxle assembly.

      A012HUR
    2. Remove the 4 bolts.

    3. Loosen the hose clamp and remove the No. 1 air tube.

  5. REMOVE STARTER ASSEMBLY (w/ Stop And Start System)

    Click hereНажмите здесь

  6. REMOVE STARTER ASSEMBLY (w/o Stop And Start System)

    Click hereНажмите здесь

  7. DISCONNECT WIRE HARNESS (w/ Stop And Start System)

    1. Disengage the 5 clamps.

      A012KCE
    2. Disconnect the back-up light switch assembly connector.

    3. Disconnect the park/neutral position switch assembly connector.

    4. Remove the nut and bolt, and disconnect the wire harness from the manual transaxle assembly.

  8. DISCONNECT WIRE HARNESS (w/o Stop And Start System)

    1. Disengage the 3 clamps.

      A012K3D
    2. Disconnect the back-up light switch assembly connector.

    3. Remove the nut and bolt, and disconnect the wire harness from the manual transaxle assembly.

  9. REMOVE MANUAL TRANSAXLE ASSEMBLY

    1. Remove the 8 bolts and manual transaxle assembly.

      A012LI2
  10. REMOVE FRONT ENGINE MOUNTING BRACKET

    1. Remove the 4 bolts and front engine mounting bracket.

      A012HEV
  11. REMOVE ENGINE MOUNTING BRACKET LH

    1. Remove the 4 bolts and engine mounting bracket LH.

      A012I3ZC01
      *A Type A
      *B Type B
  12. REMOVE REAR ENGINE MOUNTING BRACKET

    1. Remove the 4 bolts and rear engine mounting bracket.

      A012L8V
  13. REMOVE CLUTCH ACCUMULATOR ASSEMBLY

    Click here Нажмите здесь

  14. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click hereНажмите здесь

  15. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click hereНажмите здесь

  16. REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE

    Click hereНажмите здесь

  17. REMOVE WIRE HARNESS CLAMP BRACKET

    1. Remove the bolt and wire harness clamp bracket.

      A012KAK
  18. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY

    1. Remove the bolt and speedometer driven hole cover sub-assembly from the manual transaxle assembly.

      A012IJA
    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.