ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE

  1. INSTALL CRANK POSITION SENSOR

    1. Apply a light coat of engine oil to the O-ring of the crank position sensor.

      A012FDKC01
      *1 O-ring
      Note:

      If reusing the crank position sensor, be sure to inspect the O-ring.

    2. Install the crank position sensor with the 2 bolts.

      Момент затяжки
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Engage the crank position sensor wire harness clamp to the wire harness bracket.

    4. Connect the connector to the crank position sensor.

  2. INSTALL MANIFOLD STAY

    1. Install the manifold stay with 2 bolts.

      Момент затяжки
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  3. INSTALL CYLINDER BLOCK SIDE COVER

    Click here Нажмите здесь

  4. INSTALL MANIFOLD SUPPORT BRACKET

    Click here Нажмите здесь

  5. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    Click hereНажмите здесь

  6. INSPECT FOR ENGINE OIL LEAK