PROCEDURE
INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY
Using a caliper gauge, inspect the reverse idler gear sub-assembly.
Standard Inside Diameter |
---|
25.056 to 25.074 mm (0.98645 to 0.98716 in.) |
Maximum Inside Diameter |
---|
25.074 mm (0.98716 in.) |
If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.
Using a micrometer, inspect the reverse idler gear shaft.
Standard Outer Diameter |
---|
24.984 to 25.000 mm (0.98362 to 0.98425 in.) |
Minimum Outer Diameter |
---|
24.984 mm (0.98362 in.) |
If the outer diameter is less than the minimum, replace the reverse idler gear shaft.