PROCEDURE
INSTALL GENERATOR ASSEMBLY
Install the generator assembly with the 3 bolts.
Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and the generator when installing the generator assembly.
Connect the wire harness to terminal B and install the nut and bolt.
Connect the connector.
Install the terminal cap.
INSTALL V-RIBBED BELT
Click hereНажмите здесь
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Click hereНажмите здесь
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here Нажмите здесь