DESCRIPTION
While the vehicle is driven with the shift lever in E, the most appropriate gear is automatically selected according to the accelerator pedal opening angle and vehicle speed. During this time, shift control can be switched between easy (E) mode and easy sports (Es) mode by pressing the pattern select switch.
WIRING DIAGRAM
*1 | Pattern Select Switch |
PROCEDURE
INSPECT PATTERN SELECT SWITCH
Remove the pattern select switch.
*a |
Component without harness connected (Pattern Select Switch) |
Click here Нажмите здесь
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||||
---|---|---|---|---|---|---|---|---|
|
Result | |||
---|---|---|---|
|
NG |
REPLACE PATTERN SELECT SWITCH Click hereНажмите здесь |
OK |
CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
Result | |||
---|---|---|---|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
OK |
CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - TCM)
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Result | |||
---|---|---|---|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
OK |
REPLACE TCM
Replace the TCM.
for LHD: Click here Нажмите здесь
for RHD: Click here Нажмите здесь
Result | ||
---|---|---|
|
NEXT |
PERFORM INITIALIZATION
Perform the initialization and learning procedure.
Click hereНажмите здесь
Result | ||
---|---|---|
|
NEXT |
END |