Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
When removing the following parts, perform the operations correctly by following the precautions on the relevant pages.
Symptom | Suspected Area | Link |
---|---|---|
No up-shift, no down-shift Buzzer does not sound when incorrect operation occurs (built into TCM) |
Air in clutch fluid line | |
Transaxle unit (gears, bearings, shift forks, synchronizer rings, shift keys, etc.) | ||
Clutch disc (clutch cover) | ||
Clutch stroke sensor | ||
Clutch actuator assembly | Нажмите здесь | |
Shift stroke sensor | ||
Select stroke sensor | ||
Shift and select actuator | ||
Shift lever position sensor | ||
Shift lever assembly | ||
Speed signal circuit | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Multi-mode manual transaxle warning light defective | Multi-mode manual transmission warning light circuit | |
IG signal circuit | ||
ECU power source circuit | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Shift position indicator light defective | Multi-mode manual transmission warning light circuit | |
IG signal circuit | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Buzzer does not sound when incorrect operation occurs (built into TCM) | TCM (for LHD) | |
TCM (for RHD) | ||
Buzzer does not sound when incorrect operation occurs (built into combination meter) | Multi-mode manual transmission warning light circuit | |
IG signal circuit | ||
Front door courtesy switch | ||
Combination meter assembly | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Shift impossible to any gear | Transaxle unit (gears, bearings, shift forks, synchronizer rings, shift keys, etc.) | |
Shift stroke sensor | ||
Select stroke sensor | ||
Shift and select actuator | ||
Shift lever position sensor | ||
Clutch disc (clutch cover) | ||
Clutch stroke sensor | ||
Clutch actuator assembly | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Too much time lag when changing gear position | Transaxle unit (gears, bearings, shift forks, synchronizer rings, shift keys, etc.) | Нажмите здесь |
Clutch disc (clutch cover) | ||
Clutch stroke sensor | ||
Clutch actuator assembly | ||
Shift stroke sensor | ||
Select stroke sensor | ||
Shift and select actuator | ||
Shift lever position sensor | ||
Shift lock solenoid circuit | ||
Shift lever assembly | ||
Speed signal circuit | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Poor acceleration | ECD system | |
Pattern select switch | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Shift lever position cannot be changed | Shift lock solenoid circuit | |
Stop light switch circuit | ||
IG signal circuit | ||
Shift lever assembly | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
No gear change by operating the "+" or "-" shift paddle switch | Shift paddle switch circuit | Нажмите здесь |
Transmission shift main switch | ||
Shift lever position sensor | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Engine stalls when starting off or stopping | Transmission revolution sensor | |
TCM (for LHD) | ||
TCM (for RHD) | ||
Gear not automatically shifted up or down during E mode driving | CAN communication circuit | |
Transmission shift main switch | ||
Shift lever position sensor | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Mode switch operation impossible (from E to M) | Transmission shift main switch | |
Shift lever assembly | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Setting to 1st or R positions impossible | Shift lever position sensor | |
TCM (for LHD) | ||
TCM (for RHD) | ||
Shift timing delays occur during M mode driving | Accelerator pedal position sensor | |
TCM (for LHD) | ||
TCM (for RHD) | ||
Assist control does not operate when engine started | Parking brake switch circuit | |
TCM (for LHD) | ||
TCM (for RHD) | ||
Engine does not crank | ECD system | |
Starter signal circuit | ||
Stop light switch circuit | ||
Shift lever position sensor | ||
Starter (w/ Stop And Start System) | ||
Starter (w/o Stop And Start System) | ||
TCM (for LHD) | ||
TCM (for RHD) | ||
Noise | Oil (level low) | |
Oil (wrong) | ||
Gear (worn or damaged) | ||
Bearing (worn or damaged) | ||
Oil leakage | Oil (level too high) | |
Gasket (damaged) | ||
Oil seal (worn or damaged) | ||
O-ring (worn or damaged) | ||
After reassembling or repairing transaxle system components, the engine does not start. | Refer to "Engine does not Start" | |
Starter signal circuit (w/o Entry and Start System) | ||
Entry and Start System (w/ Entry and Start System) | ||
After reassembling or repairing transaxle system components, the vehicle does not move. | Refer to "Vehicle does not Move" |