ГЕНЕРАТОР СНЯТИЕ

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

   Click here Нажмите здесь

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here Нажмите здесь

3. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

   Click here Нажмите здесь

4. REMOVE V-RIBBED BELT

   Click here Нажмите здесь

5. REMOVE GENERATOR ASSEMBLY

   Remove the terminal cap.

   

   Disconnect the connector and 2 clamps.

   Remove the nut and disconnect the wire harness from terminal B.

   Fully loosen the bolt A.

   

   Tip:

   The bolt A cannot be fully removed from the bracket.

   Remove the bolt B and generator assembly.