РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с EA66) УСТАНОВКА

PROCEDURE

  1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

    1. Install the clutch release cylinder assembly and clutch line bracket to the manual transaxle assembly with the 2 bolts.

      Момент затяжки
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
  2. CONNECT CLUTCH LINE

    1. Install the clutch line clamp to the clutch release cylinder assembly with the bolt.

      Момент затяжки
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    2. Using a 10 mm union nut wrench, connect the clutch line.

      Момент затяжки
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }
      Note:
      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

        Click here Нажмите здесь

  3. FILL RESERVOIR WITH BRAKE FLUID

    Click here Нажмите здесь

  4. BLEED CLUTCH LINE

    Click hereНажмите здесь

  5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here Нажмите здесь

  6. INSPECT FOR FLUID LEAK

    Tip:

    Check for leakage in the clutch system.

  7. INSTALL BATTERY CARRIER BRACKET SUB-ASSEMBLY

    Click hereНажмите здесь

  8. INSTALL BATTERY

    Click hereНажмите здесь

  9. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereНажмите здесь

  10. INSTALL NO. 2 RADIATOR AIR GUIDE

    Click hereНажмите здесь