PROCEDURE
REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)
Click hereНажмите здесь
REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)
Click hereНажмите здесь
REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
Click hereНажмите здесь
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Click hereНажмите здесь
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Click hereНажмите здесь
REMOVE BATTERY
Click hereНажмите здесь
REMOVE NO. 2 BATTERY CARRIER
Click hereНажмите здесь
REMOVE CLUTCH ACTUATOR ASSEMBLY
Disconnect the clutch stroke sensor connector.
*a | Clutch Stroke Sensor Connector |
*b | Clutch Motor Assembly Connector |
Disconnect the clutch motor assembly connector.
Remove the bolt and disconnect the wire harness from the clutch actuator assembly.
Do not forcibly pull the clutch stroke sensor connector as this may damage the wire harness.
Using a 10 mm union nut wrench, remove the bleeder clutch release tube.
Remove the 3 bolts and clutch actuator assembly from the No. 1 clutch actuator bracket.
If a component has been dropped or subjected to a strong impact, replace it.