ДАТЧИК ХОДА СЦЕПЛЕНИЯ (для EC65A) СНЯТИЕ

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click hereНажмите здесь

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click hereНажмите здесь

  3. REMOVE CLUTCH STROKE SENSOR

    1. Disconnect the connector from the clutch stroke sensor.

      A012K0F
      Note:

      Do not forcibly pull the connector as this may damage the wire harness.

    2. Remove the 2 screws and clutch stroke sensor from the clutch actuator housing sub-assembly.

      A012JRT
    3. Remove the O-ring from the clutch stroke sensor.