РЫЧАГ ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ В СБОРЕ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE

  1. INSPECT SHIFT LOCK SOLENOID

    1. Disconnect the shift lock control unit assembly connector.

      A012MH0C01
      *a

      Component without harness connected

      (Shift Lock Control Unit Assembly)

    2. Using an ohmmeter, measure the resistance according to the value in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 - 6 20°C (68°F) 30 to 35 Ω

      If the resistance is not as specified, replace the shift lock control unit assembly.

    3. Check the solenoid operating sound when applying battery voltage across terminals 2 and 6.

      A012HJVC01
      *a

      Component without harness connected

      (Shift Lock Control Unit Assembly)

      If the solenoid does not operate, replace the shift lock control unit assembly.

    4. Connect the shift lock control unit assembly connector.

  2. INSPECT TRANSMISSION SHIFT MAIN SWITCH

    1. Disconnect the shift lock control unit assembly connector.

      A012MAMC01
      *a

      Component without harness connected

      (Shift Lock Control Unit Assembly)

      *b M Position
    2. Move the shift lever to M.

    3. Using an ohmmeter, measure the resistance according to the value in the table below.

      Standard Resistance
      Tester Connection Shift Lever Position Specified Condition
      4 - 8 M Below 1 Ω
    4. Move the shift lever to E.

      A012K9MC01
      *a

      Component without harness connected

      (Shift Lock Control Unit Assembly)

      *b E Position
    5. Using an ohmmeter, measure the resistance according to the value in the table below.

      Standard Resistance
      Tester Connection Shift Lever Position Specified Condition
      4 - 8 E 10 kΩ or higher

      If the result is not as specified, replace the shift lock control unit assembly.

    6. Connect the shift lock control unit assembly connector.

  3. INSPECT SHIFT LEVER POSITION SENSOR

    A012L7WC01
    *a

    Component without harness connected

    (Shift Lever Position Sensor)

    1. Disconnect the shift lever position sensor connector.

    2. Using an ohmmeter, measure the resistance according to the values in the table below.

      Standard Resistance
      Tester Connection Shift Lever Position Specified Condition
      4 - 9 - 10 - 13 R Below 1 Ω
      4 - 2 - 10 - 6 N Below 1 Ω
      4 - 2 - 3 - 13 E, M Below 1 Ω
      11 - 12 + Below 1 Ω
      11 - 5 - 12 M 10 kΩ or higher
      11 - 5 - Below 1 Ω

      If the result is not as specified, replace the shift lock control unit assembly.

    3. Connect the shift lever position sensor connector.