ПРИВОДНОЙ РЕМЕНЬ УСТАНОВКА

PROCEDURE

  1. INSTALL V-RIBBED BELT

    1. Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner assembly counterclockwise, and then install the V-ribbed belt.

      SST
      09216-42010

      ОСТОРОЖНО

      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the V-ribbed belt, pulleys, etc.

      Note:
      • Make sure that the V-ribbed belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.

  2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    1. Install the front suspension member reinforcement RH with the 4 bolts.

      Момент затяжки
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }
      Note:

      Temporarily tighten bolts A and B, and then fully tighten the 4 bolts in the order of C, B, D and A.

      A012LTTN01
  3. INSTALL REAR ENGINE UNDER COVER RH

    Click hereНажмите здесь

  4. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereНажмите здесь

  5. INSTALL FRONT WHEEL RH

    Момент затяжки
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }