DTC Code | DTC Name |
---|---|
P0299 | Turbocharger / Supercharger Underboost |
DESCRIPTION
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
---|---|---|---|---|---|
P0299 | Turbocharger / Supercharger Underboost | The pressure is 55 kPa below the Target Booster Pressure for 80 seconds at an engine speed of 2800 to 4400 rpm (2 trip detection logic). |
|
Comes on | DTC stored |
DTC No. | Data List |
---|---|
P0299 |
|
If DTC P0299 is stored due to the variable nozzle being stuck open, the following symptoms may appear:
Lack of power
Vehicle surge or hesitation under light or medium load
CONFIRMATION DRIVING PATTERN
DTC No. | DTC Detection Drive Pattern |
---|---|
P0299 | Accelerate vehicle with accelerator depressed halfway or more starting from a speed of 120 km/h (75 mph) or more for 2 minutes (make sure gear is fixed and does not change) |
CAUTION / NOTICE / HINT
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click hereНажмите здесь).
After replacing the suction control valve, the ECM needs initialization.
Click hereНажмите здесь
After replacing an injector assembly, the ECM needs registration.
Click hereНажмите здесь
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Comparison of the data list items MAP and Target Booster Pressure during acceleration under medium to high engine speeds can be used to determine the state of the problem.
PROCEDURE
CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0299)
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
Powertrain > Engine and ECT > Trouble CodesResult | ||||||
---|---|---|---|---|---|---|
|
If any DTCs other than P0299 are output, troubleshoot those DTCs first.
B |
GO TO DTC CHART Click here Нажмите здесь |
A |
CHECK FREEZE FRAME DATA (FUEL PRESS AND TARGET COMMON RAIL PRESSURE)
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Record the stored DTC and freeze frame data.
Powertrain > Engine and ECT > Trouble CodesResult | ||||||
---|---|---|---|---|---|---|
|
A |
INSPECT CLOGGED FUEL PIPE (LACK OF POWER OR HESITATION) Click hereНажмите здесь |
B |
GO TO LACK OF POWER OR HESITATION Click hereНажмите здесь |