PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name | See Procedure |
---|---|
Stop and Start System | |
Power Door Lock Control System | |
Simple Intelligent Parking Assist System |
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression | Ignition Switch (Position) | Engine Switch (Condition) |
---|---|---|
Ignition Switch off | LOCK | Off (Lock) |
Ignition Switch ACC | ACC | On (ACC) |
Ignition Switch ON | ON | On (IG) |
Engine Start | START | On (Start) |
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick charge.
Do not perform tests with a high voltage insulation resistance tester.
Never disconnect the battery cables while the engine is running.
Check that the charging cable nuts are tightened on terminal B of the generator and on the engine room relay block and junction block assembly.