ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ СНЯТИЕ

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER

  2. DRAIN ENGINE COOLANT

    Click hereНажмите здесь

  3. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here Нажмите здесь

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here Нажмите здесь

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here Нажмите здесь

  6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

    1. Disconnect the connector from the outlet water sub-assembly.

      A012JCJ

    2. Using a 19 mm socket wrench, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

      A012HMJ
      Note:

      If a component has been dropped or subjected to a strong impact, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.