ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ УСТАНОВКА

PROCEDURE

  1. INSTALL AIR FUEL RATIO SENSOR

    1. Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly.

      A012HASC01
      *a Length of SST 30 mm (1.18 in.)
      *b Length of Torque Wrench 300 mm (11.8 in.)
      SST
      09224-00010
      Момент затяжки
      without SST [Torque (N*m(kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }
      Note:

      If a component has been dropped or subjected to a strong impact, replace it.

      Tip:
      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here Нажмите здесь

    2. Connect the connector to the air fuel ratio sensor and wire harness clamp.

    3. Install the clamp to the air fuel ratio sensor.

  2. INSPECT FOR EXHAUST GAS LEAK