ДАТЧИК ПОЛОЖЕНИЯ РАСПРЕДВАЛА УСТАНОВКА

PROCEDURE

  1. INSTALL NO. 1 CRANK POSITION SENSOR

    1. Apply a light coat of engine oil to the O-ring of the No. 1 crank position sensor.

      A012IY8C01
      *1 O-ring
      Note:

      If reusing the No. 1 crank position sensor, be sure to inspect the O-ring.

    2. Install the No. 1 crank position sensor with the bolt.

      Момент затяжки
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }
      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the connector to the No. 1 crank position sensor.

  2. INSPECT FOR ENGINE OIL LEAK

  3. INSTALL NO. 1 ENGINE COVER

    Click hereНажмите здесь