СИСТЕМА ECD Turbocharger Noise

DESCRIPTION

Tip:

Turbocharger noise is classified into 2 types. One is whistling noise, and the other is whining noise. When troubleshooting, the type of noise should be determined first.

Table 1. Description
Noise Type Noise Description Main Trouble Area
Whistling noise The volume and pitch of this noise is proportional to turbocharger speed or engine speed. Therefore, the noise level will become more obvious when engine speed increases.
  • Turbocharger sub-assembly (e.g. shaft imbalance)

  • Gear inside engine

  • Transaxle gear

  • Intake air system leakage

  • Intake air system breakage

Whining noise This noise has a lower pitch than whistling noise. It generally occurs in the engine speed range of 1500 to 2500 rpm, and has a relatively constant pitch, independent of engine speed and vehicle speed.

Turbocharger sub-assembly

Tip:
  • Example: Vibration of turbocharger sub-assembly is transferred to the exhaust pipe which causes resonation and noise.

  • Example: Vibration of the turbocharger sub-assembly is transferred through exhaust pipe to vehicle body (floor) which then vibrates causing noise.

  1. Table 2. Turbocharger System
    Main fault Turbocharger turbine shaft imbalance
    Symptoms

    High-pitched whistling noise

    Tip:

    The pitch and volume change proportionally to the turbocharger speed.

    Table 3. Intake System
    Main fault Leakage
    Data List Leak flow noise

    Faults and Symptoms of Diesel Engine Components

    Table 4. Gear inside Engine
    Symptoms

    Gear noise

    Tip:

    The pitch and volume change proportionally to the engine speed.

    Table 5. Transaxle Gear
    Symptoms

    Gear noise

    Tip:

    The pitch and volume change proportionally to the transaxle gear speed.

PROCEDURE

  1. CONFIRM CONDITION IN WHICH NOISE OCCURRED

    1. Confirm with the customer the condition when noise occurred.

      Tip:

      To clearly understand the conditions in which the noise occurred, the items in the table below are useful.

      Item Note
      Engine speed Engine speed range
      Vehicle speed Vehicle speed range
      Transaxle gear Which gear?
      Accelerator pedal position During acceleration or deceleration?
      Temperature
      • Ambient temperature

      • Engine temperature (cold, warmed up, etc.)

      Road conditions
      • City or highway driving

      • Uphill or downhill

      Noise level
      • Did the noise occur suddenly, or build gradually?

      • Has the noise gradually been getting louder?

      Other symptoms
      • Lack of power

      • High fuel consumption, etc.

      Noise recognition What made the customer determine the noise to be abnormal?
      Result
      Proceed to
      NEXT
    NEXT
  2. CONFIRM NOISE CUSTOMER MENTIONED (PROCEDURE 2)

    1. Check for the noise described by the customer.

      Tip:

      If a noise is heard, make sure that the noise matches the noise described by the customer.

      Result
      Result Proceed to
      Obvious abnormal noise matching noise described by customer is confirmed A
      Obvious abnormal noise matching noise described by customer is not confirmed B
    B Нажмите здесь

    A
  3. CHECK INTAKE SYSTEM

    1. Check for air leakage between the air cleaner case sub-assembly and turbocharger sub-assembly, and between the turbocharger sub-assembly and intake manifold.

      Tip:
      • Check for disconnected or improperly connected hoses, and gaps between hoses and parts.

      • Check for foreign matter between the air cleaner case sub-assembly and turbocharger sub-assembly.

      Result
      Proceed to
      OK
      NG
    NG

    REPAIR OR REPLACE MALFUNCTIONING PARTS


    OK
  4. CONFIRM NOISE SOURCE (FORM TURBOCHARGER SUB-ASSEMBLY OR NOT)

    1. Connect the GTS to the DLC3.

    2. Start the engine and warm it up.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VN Turbo Open.

      Powertrain > Engine and ECT > Active Test
      Tester Display
      Activate the VN Turbo Open
    5. Perform the Active Test under the conditions* from the time the noise occurred described by the customer and compare the noise to the noise heard when not performing the Active Test and check if the noise is reduced.

      Tip:

      *: Some examples of conditions are idling, racing the engine and driving at full throttle.

      Result
      Result Proceed to
      The noise is reduced (or disappears) A
      The noise is the same as in Procedure 2 (The noise does not change) B
      Tip:
      • By performing Activate the VN Turbo Open Active Test, the variable nozzle of the turbocharger sub-assembly becomes fully open regardless of the engine condition, and the turbocharger speed does not increase.

      • If the turbocharger sub-assembly is the cause of the noise, the noise will be reduced when Activate the VN Turbo Open Active Test is performed because turbocharger speed does not increase.

    B Нажмите здесь

    A
  5. CONFIRM THE NOISE TYPE

    1. Check whether the noise can be heard even when the engine speed is higher than 3000 rpm, and whether the noise gradually gets louder as the engine speed increases.

      Tip:

      If so, the noise is likely to be whistling noise. If not, the noise is likely to be whining noise.

      Result
      Result Proceed to
      Yes (The noise is likely to be whistling noise) A
      No (The noise is likely to be whining noise) B
    A

    REPLACE TURBOCHARGER SUB-ASSEMBLY Click hereНажмите здесь


    B
  6. PERFORM ALIGNMENT OF EXHAUST PIPE AND CONFIRM THE NOISE

    1. Disconnect the exhaust pipe at the ball joint and from each exhaust pipe support, and then realign the exhaust pipe and reconnect it to each exhaust pipe support and at the ball joint.

      Click hereНажмите здесь

      A012KI2C01
      *1 Gasket (Ball Joint) *2 Compression Spring
      *3 Exhaust Pipe Support *4 Air Fuel Ratio Sensor
      *5 Front Exhaust Pipe Assembly *6 Tail Exhaust Pipe Assembly
      A012IMJ N*m (kgf*cm, ft.*lbf): Specified torque Non-reusable part
    2. Confirm whether the noise problem is solved or not.

      Tip:

      The alignment of the exhaust pipe affects whining noise.

      Result
      Result Proceed to
      The noise problem is solved A
      The noise problem remains B
    A

    END


    B

    REPLACE TURBOCHARGER SUB-ASSEMBLY Click hereНажмите здесь


  7. CHECK FOR NOISE FROM SOURCE OTHER THAN TURBOCHARGER (PROCEDURE 7)

    1. Check for the noise source.

      ОСТОРОЖНО

      When performing this check, make sure that the sound scope, your body, etc., do not get caught on the V-belt.

      Tip:
      • The source of the noise is not the turbocharger sub-assembly, but a part other than the turbocharger sub-assembly (e.g. a part inside the engine, transaxle, or vacuum pump).

      • Sometimes gear noise may be mistaken for turbocharger noise.

        For gear noise, pay attention to the gear inside the engine and transaxle gear.

      • Rev the engine up and check if the noise reduces at the same time the engine speed decreases. If the noise reduces at the same time the engine speed decreases, it is gear noise. If the noise reduces a short time after the engine speed decreases, it is turbocharger noise.

      Result
      Proceed to
      NEXT
    NEXT
  8. REPLACE THE PARTS DETECTED IN PROCEDURE 7

    1. Replace the parts detected in procedure 7 as the noise source.

      Result
      Proceed to
      NEXT
    NEXT
  9. CONFIRM WHETHER THE NOISE PROBLEM HAS BEEN SUCCESSFULLY SOLVED

    1. Check whether the noise problem has been successfully solved.

      Result
      Proceed to
      NEXT
    NEXT

    END


  10. EXPLAIN TO THE CUSTOMER THAT THE NOISE IS NORMAL

    1. Explain to the customer that the noise the customer mentioned is not abnormal.

      Tip:

      To help the customer understand, performing a test drive in another car with the customer may be helpful.

      Result
      Proceed to
      NEXT
    NEXT

    END