PROCEDURE
INSTALL SHIFT STROKE SENSOR
Apply MP grease to a new O-ring.
Install the O-ring to the shift stroke sensor.
Set the shift stroke senor so that the sensor side and actuator side sensor arms are positioned as shown in the illustration.
Turn the shift stroke sensor clockwise.
Install the 2 screws.
Connect the wire harness clamp and shift stroke sensor connector.
INSTALL AIR CLEANER BRACKET
Click here Нажмите здесь
INSTALL FUEL FILTER SUPPORT
Click here Нажмите здесь
CONNECT ENGINE WIRE
Connect the 2 engine wire connectors and 2 clamps.
Connect the ECM connector and lower the lever.
INSTALL FUEL FILTER ASSEMBLY
Click hereНажмите здесь
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here Нажмите здесь
PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSAXLE SYSTEM
Click hereНажмите здесь
PERFORM LEARNING OF MULTI-MODE MANUAL TRANSAXLE SYSTEM
Click hereНажмите здесь
PERFORM SYNCHRONIZATION POSITION CALIBRATION
Click hereНажмите здесь