PROCEDURE
INSTALL AIR FUEL RATIO SENSOR
Using SST, install the air fuel ratio sensor onto the exhaust manifold converter sub-assembly.
If a component has been dropped or subjected to a strong impact, replace it.
The "with SST" torque value is effective when SST is parallel to the torque wrench.
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).
If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.
Click here Нажмите здесь
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
*a | Length of SST 30 mm (1.18 in.) |
*b | Length of Torque Wrench 300 mm (11.8 in.) |
INSTALL WIRE HARNESS CLAMP BRACKET
w/ No. 1 Engine Cover
Install the wire harness clamp bracket.
Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.
Connect the connector to the air fuel ratio sensor.
w/o No. 1 Engine Cover
Install the wire harness clamp bracket.
Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.
Connect the connector to the air fuel ratio sensor.
Install the nut.
INSTALL NO. 2 ENGINE COVER BRACKET (w/ No. 1 Engine Cover)
Install the No. 2 engine cover bracket with the 2 nuts.
INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
Click here Нажмите здесь
INSTALL OUTER COWL TOP PANEL
for LHD: Click here Нажмите здесь
for RHD: Click here Нажмите здесь
PERFORM INITIALIZATION
Click hereНажмите здесь