РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с EA66) ПОВТОРНАЯ СБОРКА

PROCEDURE

  1. INSTALL CLUTCH RELEASE CYLINDER KIT

    1. Coat a new piston with lithium soap base glycol grease as shown in the illustration.

      A012GZVC01
      A012M0O lithium soap base glycol grease
    2. Install the piston and a new spring to the clutch release cylinder body.

      A012KQHC01
      *1 Spring
      *2 Piston
      *3 Push Rod
      *4 Boot
      Note:

      Do not damage the inside of the clutch release cylinder body.

      Tip:

      Install the smaller end of the spring to the piston.

    3. Install a new boot to the push rod.

    4. Install the push rod to the clutch release cylinder body.

  2. INSTALL RELEASE CYLINDER BLEEDER PLUG

    1. Install the release cylinder bleeder plug to the clutch release cylinder body.

      Момент затяжки
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }
    2. Install the bleeder plug cap to the release cylinder bleeder plug.