РЕЛЕ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE

  1. INSPECT EFI-MAIN

    1. Measure the resistance according to the value(s) in the table below.

      A012HET
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EFI MAIN relay.

  2. INSPECT EFI MAIN NO. 2 RELAY

    1. Measure the resistance according to the value(s) in the table below.

      A012HET
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EFI MAIN NO. 2 relay.

  3. INSPECT IG2 RELAY

    1. Measure the resistance according to the value(s) in the table below.

      A012HET
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the IG2 relay.

  4. INSPECT EDU RELAY

    1. Measure the resistance according to the value(s) in the table below.

      A012HET
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EDU relay.