ГОЛОВКА БЛОКА ЦИЛИНДРОВ ПОВТОРНАЯ СБОРКА

PROCEDURE

  1. INSTALL NO. 1 WITH HEAD TAPER SCREW PLUG

    1. Install a new gasket to the No. 1 with head taper screw plug.

      A012HW3
    2. Using a 6 mm hexagon socket wrench, install the No. 1 with head taper screw plug.

      Момент затяжки
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }
  2. INSTALL VALVE ROCKER ARM PIVOT

    1. Install the valve rocker arm pivot to the cylinder head sub-assembly.

      A012K5Y
      Момент затяжки
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
  3. INSTALL VALVE SPRING SEAT

    1. Install the valve spring seat to the cylinder head sub-assembly.

  4. INSTALL VALVE STEM OIL SEAL

    1. Apply a light coat of engine oil to the lip of a new valve stem oil seal.

      A012G3G
  5. INSTALL INTAKE VALVE

    1. Install the intake valve, outer compression spring and valve spring retainer to the cylinder head sub-assembly.

    2. Using SST, install the 2 valve spring retainer lock halves.

      A012KFUE01
      SST
      09202-70020   ( 09202-00010 )
    3. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure that it fits properly.

      A012ICA
      Note:

      Do not damage the valve stem tip.

  6. INSTALL EXHAUST VALVE

    1. Install the exhaust valve, outer compression spring and valve spring retainer to the cylinder head sub-assembly.

    2. Using SST, install the 2 valve spring retainer lock halves.

      A012MGME01
      SST
      09202-70020   ( 09202-00010 )
    3. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure that it fits properly.

      A012MYZ
      Note:

      Do not damage the valve stem tip.

  7. INSTALL VALVE STEM CAP

    1. Apply a light coat of engine oil to the 8 valve stem caps.

    2. Install the 8 valve stem caps.