ПРИВОД ВЫБОРА И ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ СНЯТИЕ

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here Нажмите здесь

  2. REMOVE BATTERY

    Click here Нажмите здесь

  3. REMOVE FUEL FILTER ASSEMBLY

    Click hereНажмите здесь

  4. DISCONNECT ENGINE WIRE

    Click hereНажмите здесь

  5. REMOVE FUEL FILTER SUPPORT

    Click here Нажмите здесь

  6. REMOVE AIR CLEANER BRACKET

    Click here Нажмите здесь

  7. REMOVE NO. 1 AIR TUBE

    1. Disconnect the wire harness clamp.

      A012KUKC01
      *a Hose Clamp
    2. Remove the 4 bolts.

    3. Loosen the 2 hose clamps and remove the No. 1 air tube.

  8. DISCONNECT WIRE HARNESS

    1. Disconnect the 5 wire harness clamps.

      A012M69
    2. Disconnect the 6 connectors.

      A012FUF
    3. Disconnect the select stroke sensor connector.

      A012LV4
    4. Disconnect the 3 wire harness clamps.

  9. REMOVE SHIFT AND SELECT ACTUATOR ASSEMBLY

    1. Remove the bolt and wire harness clamp bracket from the shift and select actuator.

      A012LMW
    2. Remove the bolt and wire harness clamp bracket from the shift and select actuator.

      A012J7L
    3. Remove the 6 bolts, wire harness clamp bracket and shift and select actuator from the transaxle case.

      A012M8D
    4. Remove the 2 ring pins from the shift and select actuator.

      A012KF0
    5. Remove the bolt and breather protector from the shift and select actuator.

      A012N9X
    6. Remove the breather plug cap from the shift and select actuator.

      A012LXJ