PROCEDURE
INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
Install a new front drive shaft hole snap ring.
Face the end gap of the front drive shaft hole snap ring downward.
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the splines of the front drive inboard joint assembly with gear oil.
Coat the lip of the transmission case oil seal with MP grease.
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.
Face the end gap of the front drive shaft hole snap ring downward.
Do not damage the transmission case oil seal.
Do not damage the front axle inboard joint boot.
Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.
*a | Matchmark |
Be careful not to damage the front axle outboard joint boot.
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Perform the same procedure as for the LH side.
CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Click hereНажмите здесь
INSTALL FRONT STABILIZER LINK ASSEMBLY
Click hereНажмите здесь
CONNECT TIE ROD END SUB-ASSEMBLY
Click hereНажмите здесь
INSTALL FRONT FLEXIBLE HOSE
Click hereНажмите здесь
INSTALL FRONT SPEED SENSOR
Click hereНажмите здесь
INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new drive shaft.
Keep the threaded parts free of oil and foreign matter.
Using a 30 mm socket wrench, install the front axle shaft nut.
Keep depressing the brake pedal to prevent the drive shaft from rotating.
Using a chisel and a hammer, stake the front axle shaft nut.
ADD MANUAL TRANSAXLE OIL
for Manual Transaxle: Click hereНажмите здесь
for Multi-Mode Manual Transaxle: Click hereНажмите здесь
INSPECT FOR OIL LEAK
INSTALL REAR ENGINE UNDER COVER LH
INSTALL REAR ENGINE UNDER COVER RH
INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)
INSTALL FRONT WHEELS
ADJUST FRONT WHEEL ALIGNMENT
Click hereНажмите здесь
CHECK FOR SPEED SENSOR SIGNAL
w/o VSC: Click hereНажмите здесь
w/ VSC: Click hereНажмите здесь